By mazidi pdf

If it does, send 99H to P2; otherwise, it stays cleared. If both registers have the same value, 00 is placed in A. Instruction According to the test results, place the temperature value into the registers indicated by the following. Put two highs at the start and end of the data. Send the byte LSB first. This is widely used for the new generation of microcontrollers. Using the inverting and Ex-OR operators, respectively.

Examine the contents of the code space to locate the values. The LSB should go out first. The MSB should go out first. The LSB should come in first. The MSB should come in first. Verify also that the information is not corrupted. Start the timer Program 4. Stop the timer 6. Clear the TF flag for the next round 7. TMOD is loaded. Steps to Mode 1 6. Timer 0 counts up with the passing of each clock, which is provided by the crystal oscillator. At that point, the JNB instruction falls through.

In other words, Timer 0 counts up each 1. To get a more accurate timing, Mode 1 we need to add clock cycles due to this instructions in the loop.

CLR P2. This plus Rolling over to 0 goes through a total of clock cycles, where each clock is 1. Find the delay in ms. Programming CLR P2. As a result, it goes through a total Of states. In your calculation do not include the overhead due to Instructions in the loop. Also notice that the high portion and low portion of the square wave pulse are equal. In the above calculation, the overhead due to all the instruction in the loop is not included. Divide the desired time delay by 1.

Perform — n, where n is the decimal Values value we got in Step1 3. Show the program for timer 0 to create a pulse width of 5 ms on P2. Programming This means that out of many 1. To get that, we divide one by the other. Look at the following steps. The program is as follow. Start timer 4. Clear the TF flag 6. In mode 2 we do not need to reload TH since it is auto-reload. Remember that we only use the right two digits and ignore the rest since our data is an 8-bit data.

Since ports are set up for output when the is powered up, we make P3. In other words, we must configure set high the T1 pin pin P3. Use Timer 0, mode 1 bit to create the delay. Use Timer 1, mode 1 to create the delay. Use Timer 0, mode 2 8-bit auto-reload to create the delay. Use Timer 1, mode 2 to create delay.

Start the count at 0H. Set by HW at the begin of the stop bit mode 1. The TH1 is loaded with one of the values to set baud rate for serial data transfer Programming 3. The SCON register is loaded with the value Serial Data 50H, indicating serial mode 1, where an 8- bit data is framed with start and stop bits Transmitting 4.

TR1 is set to 1 to start timer 1 5. The character byte to be transferred serially is written into SBUF register 7. The start bit is transferred 3. Simple, concise examples are utilized to show what action each instruction performs, then a sample is provided to show its application. For anyone interested in learning about the microcontrollers.

Information about the book : Title : The microcontroller and embedded systems. Language : English. Size : 4.

Pages : Format : pdf. Year : Edition : 2. Contents of the book : Chapter 1: Introduction to Computing. Chapter 2: The Microcontrollers. Chapter 3: Assembly Language Programming. Chapter 4: Branch Instructions. Chapter 6: Addressing Modes. Chapter 8: Programming in C. Chapter 9: Hardware Connection and Hex File. Chapter Interrupts Programming in Assembly and C. Disclaimer : BooksWarrior does not own this book pdf, neither created nor scanned.

We just provide the link already available on the internet and in google drive. If in any way it violates the law or has any issues then kindly mail us [email protected] to request removal of the link.