Eurochron watch manual

The factory preset time zone is Pacific standard time. You can set an alternative time zone as follows:. The proper date will be calculated by the internal computer. Press the T1 button to confirm and set the desired time. The hands and day will automatically follow.

The battery should be replaced by trained personnel to avoid damage and ensure water resistance according to the factory specifications. After battery replacement the hands of your atomic watch must be repositioned to 12 o'clock.

The hands can be advanced wither incrementally by repestedly pressing the T2 button or rapidly by holding the T2 button for about 4 seconds then releasing. After repositioning all hands to he 12 o'clock position, confirm this by pressing the T1 button. Your atomic watch will automatically receive the WWVB signal and set itself to the Pacific standard time. You must then either press the T1 button to confirm the time or set the desired time zone as described in 4. If you find yourself outside of the reception range or in a disturbance field, you need to synchronized the time manually as follows.

Press the T1 and T2 buttons simultaneously until the digital display goes blank approximately 3 seconds. After releasing the buttons, the hands of your radio controlled watch mush be repositioned to 12 o'clock.

The hands can be advanced wither incrementally by repeatedly pressing the T2 button or rapidly by holding the T2 button pressed. When will the Anthorn transmitter be off the air? Do not use any push-but tons! Manual Rec eption Mode. This product is not a to y and does not belong in the hands of childr en. Posted on Aug 21, Does my watch contain any radioactive material? Do not recharge normal, non-r echargeable bat teries, risk o f explosion!

This Eurochron Radio Controlled Wall Clock shows the time of the day on an easily readable analogue clockface. This makes it very comfortable to wear. T he warr anty will be void in the e vent of damage caused b y. Can the Radio Controlled clock be wired to control timing circuits?

The watch s tarts an attempt t o rec eive the DCF signal. Question about Watches Open Question Eurochron watch setting. The watch automatically does summer and winter time adjustments and can be set at European time. Since the beginning of time, man has been fascinated with the measurement of time and has devised ayomic accurate machines to trap and measure time.

The atomic clock is the standard measure of time: The digital display will show the running seconds. Press the manual time setting tab on the back of the clock 15 times. The signal is also used in homes and offices around the country. If you find yourself outside of the reception range or in a disturbance field, you need to synchronized the time manually as follows. It is not possible to set the date in the manual synchronized mode.

After new battery unable to re-set. Note that your wacth watch will not receive the WWVB time signal if set to a time zone other than pacific, mountain, central, or eastern standard time.

Reproduction by any method, e. Reprinting, also in part, is prohibited. These ope- rating instructions represent the technical status at the tim … 4. Alle rechten, vertaling inbegrepen, voorbehouden. Nadruk, ook van uittreksels, verboden. Deze gebruiksaanwijzing voldoet aan de technische stand bij het in druk bezorgen.

Wijziging va … 8.